| |
| |
| |
|
Page: 1 2 3 4 5 6 7 8 9 10 11
Comments:
<dfdf> is there any reason why my safe mode would work once and not again after that
<dfdf> i tried it earlier today for the first time
<dfdf> and it worked fine
<dfdf> then i rebooted
<dfdf> and it hasnt worked since
<MInne> hi what program can i use to bost start up and clos down?
<MInne> i think windows work to slow for my computer
<MInne> any one?
<ManKind> MInne disable apps you dont use
<MInne> dont help mush
<MInne> only starte steam and fw/virus proteion
<ManKind> ?
<MInne> so there is not a start up boost program?
<ManKind> !english
<CyberGeek> English Only Please - Les Anglais Seulement Satisfont - Englisch Nur Gefällt - Gli Inglesi Soltanto Soddisfano - Somente inglês por favor - Solamente Ingles Por Favor - Kun engelsk tale - Vorbiti numai engleza - Endast engelska, tack
<CyberGeek> ingliz biss jekk joghgbok - agglika mono edo sas parakalo
<MInne> i speak english ?
<MInne> is it bad ?
<MInne> hehe
<MInne> i got 2 in schol
<MInne> :)
<CyberGeek> :)
<MInne> but i speak well :)
<MInne> hehe
<MInne> dude u sure about that?
<MInne> it most be a start up boost Software 4 windows?
<ManKind> ?
<MInne> ?
<dfdf> can anybody answer my question?
<MInne> i need start up boost 4 windows where to get?
<ManKind> dfdf what does it do when it doesnt statr
<MInne> i got 3 ghz amd 64bit and windos work slow
<MInne> windwos burn in hell :)
<MInne> win xp 64 work faster
<MInne> had it befor
<MInne> thats silly
<ManKind> bootvis will tell you what is taking long to load
<MInne> i got 0 virus
<ManKind> wtg
<MInne> okie
<MInne> thanks dude: )
<ManKind> np
<MInne> boostvis is good software?
<MInne> BootVis 1.3.37.0 best?
<dfdf> oh
<dfdf> it loads on the dell screen
<dfdf> the little Dell loading bar
<MInne> dell ****s :)
<dfdf> if im trying to boot normally
<MInne> fx ftw
<dfdf> it will get to the windows loading screen
<dfdf> then the monitor cuts out, over range or whatever
<dfdf> ya, over range
<dfdf> if I try to get into safe mode
<dfdf> I pick safe mode, another screen comes up
<dfdf> a bunch of lines
<dfdf> like
<MInne> so i most start in safe mode`?
<MInne> :Ø
<dfdf> multi @ disk @ partition @ System/blah/blah/driver/ whatever
<MInne> what button to push to pick safe mode ?
<dfdf> and it just stays in that screen
<dfdf> but the first time I tried to get into safe mode, it worked
<MInne> i only get it when i do some ting worng hehe
<dfdf> it took about a minute, then worked
<dfdf> but now I can leave it all night, and it stays at that screen
<MInne> but my old computer starte up on 30 sec ^^
<dfdf> hit the green start button
<MInne> this one is beter and slower in start up but own in benching
<dfdf> Run
<dfdf> and type in msconfig
<dfdf> press enter
<dfdf> go to the last tab over to the right
<dfdf> and uncheck any processes that you dont need to auto run
<MInne> are you telling all this to me?
<MInne> hehe
<dfdf> this last little bit yes
<MInne> i havent read hafe of it :)
<dfdf> thats ok
<dfdf> doesnt hurt me
<dfdf> heh
<MInne> what
<MInne> my english skills is good
<MInne> but not on board ^^
<MInne> norsk
<MInne> ^^
<MInne> å
<MInne> bootvis sayS : Warinig! Disk write caching is disabeld?
<MInne> can this have any ting to do whit slow up start
<ManKind> we will not troubleshoot bootvis logs for you
<phlyback> that's only a performance concern
<phlyback> yes
<phlyback> it can
<phlyback> but it might have been disabled because of known bugs with the drive
<MInne> okie
<MInne> thx
<phlyback> or because you disabled it for data security
<phlyback> cause with a write cache
<phlyback> if the power failes before the data is commited
<phlyback> that data is lost
<MInne> oh
<MInne> ah
<roto> dont get kinky now
<blackdevl> shake!
<ManKind> frylock!
<roto> meatball!
<ManKind> wad*
<roto> sorry
<roto> meatwad
<ManKind> NP
<ManKind> sorry caps
<ManKind> http://www.rit.edu/~gjj2192/hol/media/carl1.jpg
<roto> hot carl?
<roto> hawt
<j0p> hello
<j0p> maybe this is a dumb question but i havent found a solution...i need to have 2 wireless card configurations (ip,gateway,netmask ecc) to chose from
<j0p> is it possible to have more than 1 network card ip profile ?
<ManKind> dhcp
<j0p> one of the network im using doesnt have dhcp
<j0p> so i have to set manually ip,gateway ecc
<j0p> but this doesnt work with hotspots ecc
<j0p> where dhcp setting is needed
<blackdevl> any good wmv rippers?
<magikman> eac
<j0p> eac ?
<magikman> http://www.exactaudiocopy.de/
<magikman> that program kicks ***
<magikman> hehe
<magikman> he said wmv :p
<magikman> oops
<blackdevl> yeah its streaming
<blackdevl> i need a music video
<bofh``> ?? need
<CyberGeek> need == You don't NEED an application. You definately don't NEED a game or site. You do not NEED a shell. You do not NEED to get a ban lifted. You NEED food. So go and buy your food, and if you feel that you absolutely NEED a program, we suggest that you go and buy that too while you're out.
<^-Lord-^> for anyone that tried to help with the form I am doing, thanks
<^-Lord-^> I am about done now
<^-Lord-^> and I learned a lot with all your help
<Treval> :O
<^-Lord-^> Trev: can I ask you a question?
<Treval> Sure.
<^-Lord-^> these should be easy for you
<^-Lord-^> 1. I want to put a print button on the page that will print only pages 1 and 2
<^-Lord-^> 2. I want to put a button on the page that will clear all fields
<Treval> Hm don't know about print functions.
<^-Lord-^> did you get what I said earlier about that last name. first name thing>
<^-Lord-^> it was such an easy solution, that I wanted to cry
<Treval> All you have to do is call the method to print and link that method to the button..and...call the method for clearing fields.
Return to
#windowsxp
or
Go to some related
logs:
#gamedev
#politics
port+3389tcp
belsarus
#flash
#politics
mx-1 thermal greese
#computers
#windowsxp
#politics
|
|
