| |
| |
| |
|
Page: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26
Comments:
<0> pb, because you can
<1> PIZZA, COOL!
<1> *********ion alternative
<2> - /10 ? 8 bits per byte plus two bits of overhead?
<1> why you do dat dimmy?
<0> early 80s' would probably work better
<3> Smurfing: that's what you get for getting T1.
<3> SDSL is cheaper and faster!
<4> Smurfing; give or take, yes. protocol overhead, packet overhead, etc. are these HDSL or what sort of T1 ?
<0> i woulda gotten a cable modem
<4> are they actually 1.544Mbps T1 or are they 1.1mbps mostly T1 or frame relay or what?
<0> but that's just me
<3> fractional t1.
<5> david koresh surfin' the web on a factional T1.
<2> 64k/channel, full T1s, 1.544Mbps, I think it's point to point into AT&T's NOC in North Little Rock.
<2> or POP, I should say
<4> smurf; and who's the ISP ?
<0> heh att
<2> AT&T
<3> ppp t1?
<0> sweet
<2> yes
<3> hdlc > ppp
<0> why didn't you just get a cable connection
<4> Smurfing; have fun. if thats yur primary data circuit, AT&T could give a **** about a little guy like you, and won't do squat to trouble shoot.
<5> encap ppp
<6> ok, 0 errors
<3> encap hdlc
<4> cyclinder; a full p*** of all tests?
<2> There is no cable here or DSL
<6> I downloacked it to 333Mhz from 400 that is was
<6> yeah peerce
<6> hey should I change something else on the BIOS, accept the timing?
<6> I seen those
<2> encapsulation ppp
<0> mother****ing piece of ****
<6> dram timing
<5> i gotta go take a ppp.
<3> are you using compression smurfing
<6> cas latency time
<2> sartan: don't think so
<6> ras active time
<6> precharge time
<0> cyclinder, wait and see if the problem returns
<3> do you operate the t1 endpoint?
<6> and cas to delay
<4> cyclinder; your "page fault in unpaged area" problem could well be a buggy device driver or something similar, and not memory at all.
<6> I should be the mem
<2> I operate my T1 router.
<6> It all started when I upgraded
<4> smorf; why?
<2> AT&T helped me config it
<3> Smurfing: is it a cisco?
<6> should I look for other BIOS options as well?
<0> it's prolly a netopia :P
<2> peerce: cuz it's cheaper, yes it's a 2610
<6> as the timing?
<0> cyclinder, WAIT AND SEE IF THE PROBLEM STILL EXISTS
<4> smurf; then you get to trouble shoot it. have fun!!
<0> jeez
<1> mmMmmdriedMangoSliceswithCayenneSugarmmMMmmMMm
<6> Gimp-Work: I am not good on BIOS settings, I am just asking all this , to have a good test, and as well know if that option doesnt come with some other as well ...
<0> the only other setting i would change
<3> Smurfing: if you like paste me the config for the interface t1 or interface s0/1 etc -- omitting the ip addresses if you like. i can see if they've put anything on there that you don't mean
<0> is CAS to 2.5
<6> does or doesnt
<3> need
<0> the rest you need to leave alone
<3> also show me the output of the 'show controller s0' command, 'show interface s0' command
<0> only change the cas if it's still ****ed up
<6> that the default I thing Gimp-Work
<2> sartan: thanks, one sec..
<3> if it's a serial interface.
<3> in private so we don't spam the channel
<6> think
<0> like i said
<3> i have a 2610 sitting right beside me
<0> the problem may be resolved already
<7> jesus christ, this kid on dr. phil weighs 1,000lbs
<0> lol
<0> pwned
<7> but he's a ****ing victim
<7> it's a disease
<0> what kinda scale did they use
<7> what-the-****-ever
<4> cyclinder; add .5 to the CAS timing, try it again. if its 2.5, go for CAS 3. etc.
<0> peerce, it hasn't crashed yet
<0> lol
<3> actually it's a cisco 2621XM.
<3> no fair-queue !
<8> With Advanced Installer you can install ODBC drivers, data sources and translators. Advanced Installs offers a user-friendly way of setting attributes for the selected ODBC drivers, data sources and translators.
<7> winamp does that
<0> i like the nullsoft installer
<0> that's all i use for distributing apps
<0> it's teh pwn
<0> http://techreport.com/onearticle.x/9354
<4> stuff packaged with WISE always seems reasonable to me, but I've never actually used it to build packages
<9> someone should poke that kid with a stick
<1> I LIKE THE WAY YOU MOVE
<6> rehi
<6> thanks for the help
<6> dd
<10> has anyone done a migration from sql server 2000 to sql server 2005 express?
<0> uh\
Return to
#windows
or
Go to some related
logs:
tcl rehash command
NetBSD bootmenu
#windows
footman frenzy +warcarft
#beginner
#windows
#mirc
#windows
#computers
#ubuntu
|
|