<1> http://nanobobano.ath.cx/uploaded/mouse_trim_problem.3dm <1> i am trying to trim those two surfaces to make a mouse <1> mouse shape <1> one of them is polysurface and one of them is surface, is that why the trim failed? i also tried split but it failed too <1> I created the polysurface by drawing a curve and extrude it...why did it become polysurface? <2> heyoo <3> hi <2> sup? :) <3> trying to find a new crib in helsinki <2> crib=? <3> apartment <2> u moving? <3> yeah
<2> what 4? <3> starting school and going freelance <2> goodie <2> am about to start a new project <2> beagle 2 mars rover :D <3> :) <2> ...after watching the transformersmovie.com site <2> :D <2> found quite good material <2> hope i don't get stuck again because of lack of reference :/ <2> off i go to play a bit of titan quest <2> l8r <1> http://nanobobano.ath.cx/uploaded/mouse_trim_problem.3dm